Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1265)

Brocade Mobility RFS Controller CLI Reference Guide 1257
53-1003098-01
26
Parameters
accounting access-method [all|console|ssh|telnet] {(console|ssh|telnet)}
accounting [auth-fail|commands|session]
accounting server preference
[authenticated-server-host|authenticated-server-number|
authorized-server-host|authorized-server-number|none]
accounting server <1-2> retry-timeout-factor <50-200>
access-method Configures TACACS accounting access mode. The options are: console, SSH, Telnet, and all
all Configures TACACS accounting for all access modes
console Configures TACACS accounting for console access only
ssh Configures TACACS accounting for SSH access only
telnet Configures TACACS accounting for Telnet access only
auth-fail Enables accounting for authentication fail details. This option is disabled by default.
commands Enables accounting of commands executed. This option is disabled by default.
session Enables accounting for session start and stop details. This option is disabled by default.
server Configures a TACACS accounting server
preference Configures the accounting server preference (specifies the method of selecting a server, from the pool, to
send the request)
authenticated-server-host Sets the authentication server as the accounting server. This is the default setting.
This parameter indicates the same server is used for authentication and accounting. The server is
referred to by its hostname.
authenticated-server-number Sets the authentication server as the accounting server
This parameter indicates the same server is used for authentication and accounting. The server is
referred to by its index or number.
authorized-server-host Sets the authorization server as the accounting server
This parameter indicates the same server is used for authorization and accounting. The server is referred
to by its hostname.
authorized-server-number Sets the authorized server as the accounting server
This parameter indicates the same server is used for authorization and accounting. The server is referred
to by its index number.
none Indicates the accounting server is independent of the authentication and authorization servers
server <1-2> Configures an accounting server. Up to 2 accounting servers can be configured
retry-timeout-factor
<50-200> Sets the scaling factor for retry timeouts
•
<50-200> – Specify a value from 50 - 200. The default 15 100.
A value of 100 indicates the time gap between two consecutive retires remains the same irrespective of
the number of retries.
A value lesser than 100 indicates the time gap between two consecutive retries reduces with each
successive retry.
A value greater than 100 indicates the time gap between two consecutive retries
increases with each successive retry.