Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 591)

578 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
controller [adopted-devices|adoption|group|hello-interval|vlan|host]
controller adopted-devices [aps|controllers]
controller adopted-devices [aps {controllers}|controllers {aps}]
controller adoption
controller [group |vlan <1-4094>]
controller hello-interval <1-120> adjacency-hold-time <2-600>
controller host [|] {ipsec-secure|level|pool|remote-vpn-client}
controller host [|] {level [1|2]|pool <1-2> level [1|2]}
{(ipsec-secure {gw})}
controller host [|] {remote-vpn-client}
Parameters
controller adopted-devices [aps {controllers}|controllers {aps}]
controller adoption
controller [group |vlan <1-4094>]
controller hello-interval <1-120> adjacency-hold-time <2-600>
controller Configures the WLAN’s controller settings
adopted-devices Configures the types of device (AP/controller) this controller can adopt
aps {controllers} Enables the adoption of access points by this controller. This is the default setting.
•
controllers – Optional. Enables the adoption of controllers by this controller
All adopted devices (referred to as adoptee) receive complete configuration from the adopting controller
(referred to as adopter).
controllers {aps} Enables the adoption of controllers by this controllers
•
aps – Optional. Enables the adoption of access points by this controller
A controller cannot be configured as an adoptee and an adopter simultaneously. In other words, an
adopted controller (adoptee) cannot be configured to adopt another controller.
Use the no > controller > adopted-devices command to remove this setting.
controller adoption Enables adoption of the logged wireless controller or service platform
Use the no > controller > adoption command to disable adoption.
controller Configures the WLAN’s controller settings
group
> Configures the wireless controller or service platform group
•
– Specify the wireless controller or service platform group name.
vlan <1-4094> Configures the wireless controller or service platform VLAN
•
<1-4094> – Specify the VLAN ID from 1 - 4094.
controller Configures the WLAN’s controller settings
hello-interval <1-120> Configures the hello-interval in seconds. This is the interval between consecutive hello packets
exchanged between AP and wireless controller or service platform.
•
<1-120> – Specify a value from 1 - 120 seconds.
adjacency-hold-time
<2-600> Configures the adjacency hold time in seconds. This is the time since the last received hello packet, after
which the adjacency between wireless controller or service platform and AP is lost, and the link is
re-established.
•
<2-600> – Specify a value from 2 - 600 seconds.