Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 262)

246 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Example
rfs7000-37FABE(config-event-system-policy-TestPolicy)#event br adopted syslog
default
rfs7000-37FABE(config-event-system-policy-TestPolicy)#
rfs7000-37FABE(config-event-system-policy-TestPolicy)#no event br adopted
syslog
rfs7000-37FABE(config-event-system-policy-TestPolicy)#
Related Commands:
firewall-policy
Global Configuration Commands
Configures a firewall policy. This policy defines a set of rules for managing network traffic and
prevents unauthorized access to the network behind the firewall.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
firewall-policy
Parameters
firewall-policy
Example
rfs7000-37FABE(config)#firewall-policy test
rfs7000-37FABE(config-fw-policy-test)#?
Firewall policy Mode commands:
acl-logging Log on flow creating traffic
alg Enable ALG
clamp Clamp value
dhcp-offer-convert Enable conversion of broadcast dhcp offers to
unicast
dns-snoop DNS Snooping
firewall Wireless firewall
flow Firewall flow
ip Internet Protocol (IP)
ip-mac Action based on ip-mac table
logging Firewall enhanced logging
no Negate a command or set its defaults
proxy-arp Enable generation of ARP responses on behalf
of another device
event Configures the action taken for each event
Specify the firewall policy name. If a firewall policy does not exist, it is created.