Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 696)

Brocade Mobility RFS Controller CLI Reference Guide 683
53-1003098-01
7
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#no
dhcp-relay-incoming
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#no ip dhcp client
request options all
The following example shows the VLAN interface settings after the ‘no’
commands are executed:
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#show context
interface vlan8
ip address 10.0.0.1/8
ip helper-address 172.16.10.3
ip nat inside
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
Related Commands:
shutdown
interface-config-vlan-instance
Shuts down the selected interface. Use the no shutdown command to enable an interface.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
shutdown
Parameters
None
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#shutdown
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#show context
interface vlan8
ip address 10.0.0.1/8
ip helper-address 172.16.10.3
shutdown
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
crypto Defines the encryption module
description Defines the VLAN description
dhcp-relay-incoming Allows an onboard DHCP server to respond to relayed DHCP packets on this interface
ip Configures IP config commands
shutdown Disables an interface
use Defines the settings used with this command