Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1335)

Brocade Mobility RFS Controller CLI Reference Guide 1327
53-1003098-01
Chapter
29
FIREWALL LOGGING
This chapter summarizes firewall logging commands in the CLI command structure.
The firewall uses logging to send system messages to one or more logging destinations, where they
can be collected, archived and reviewed.
Set the logging level to define which messages are sent to each of the target destinations.
Logging messages can be sent to any of the following destinations:
• The firewall console
• Telnet or SSH session to the firewall
• A temporary buffer internal to the firewall
• Syslog server
• E-mail addresses
• An FTP server
Firewall Log Terminology and Syslog Severity Levels
Abbreviation Description
FTP File transfer protocol
ACL Access control list
Src MAC Source MAC address
Dest MAC Destination MAC address
LOGRULEHIT ACL rule applied
PKT DROP Packet drop
Src IP Source IP address
Dest IP / Dst IP Destination IP address
FWSTARTUP Firewall enabled
DP Destination port
SP Source port
Matched Temporary Rule This is a internal rule created to allow data traffic
Syslog Severity Level as Message Severity Level as Numeric Description
emergency 0 System is unusable
alert 1 Immediate action needed
critical 2 Critical condition