Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 97)

80 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
drwx Sat Jan 1 00:00:09 2000 startuplog
-rw- 176128 Fri Feb 15 14:32:51 2013 out.tar
rfs4000-229D58#
boot
Privileged Exec Mode Commands
Specifies the image used after reboot
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
boot system [primary|secondary] {on }
Parameters
boot system [primary|secondary] {on }
Example
rfs4000-229D58#show boot
-----------------------------------------------------------------------------
---
IMAGE BUILD DATE INSTALL DATE VERSION
-----------------------------------------------------------------------------
---
Primary 01:29:2013 22:34:21 01:16:2013 22:34:00 5.5.0.0-018D
Secondary 01:25:2013 21:56:47 01:13:2013 22:57:12 5.5.0.0-017D
-----------------------------------------------------------------------------
---
Current Boot : Primary
Next Boot : Primary
Software Fallback : Enabled
rfs4000-229D58#
rfs4000-229D58#boot system secondary
Updated system boot partition
rfs4000-229D58#
rfs4000-229D58#show boot
-----------------------------------------------------------------------------
---
system
[primary|secondary] Specifies the image used after a device reboot
•
primary – Uses the primary image after reboot
•
secondary – Uses the secondary image after reboot
on Optional. Specifies the primary or secondary image location on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.