Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 676)

Brocade Mobility RFS Controller CLI Reference Guide 663
53-1003098-01
7
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
duplex [auto|half|full]
Parameters
duplex [auto|half|full]
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#duplex full
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
duplex full
dot1x supplicant username Bob password 0 motorolasolutions@123
ip dhcp trust
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
ip
interface-config-instance
Sets the ARP and DHCP components for this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ip [arp|dhcp]
ip [arp [header-mismatch-validation|trust]|dhcp trust]
auto Enables automatic duplexity on an interface port. The port automatically detects whether it should run in
full or half-duplex mode. (default setting)
half Sets the port to half-duplex mode. Allows communication in one direction only at any given time
full Sets the port to full-duplex mode. Allows communication in both directions simultaneously
no Reverts to default (auto)