Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 111)

94 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
cluster start-election
Parameters
cluster start-election
Example
rfs7000-37FABE#cluster start-election
rfs7000-37FABE#
Related Commands:
configure
Privileged Exec Mode Commands
Enters the configuration mode. Use this command to enter the current device’s configuration
mode, or enable configuration from the terminal.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
configure {self|terminal}
Parameters
configure {self|terminal}
Example
rfs7000-37FABE#configure self
Enter configuration commands, one per line. End with CNTL/Z.
start-election Starts a new cluster master election
create-cluster Creates a new cluster on a specified device
join-cluster Adds a controller, as cluster member, to an existing cluster of devices
self Optional. Enables the current device’s configuration mode
terminal Optional. Enables configuration from the terminal