Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1219
Brocade Mobility RFS Controller CLI Reference Guide
1211
53-1003098-01
23
session
vlan
Usage Guidelines:
The working status of a pseudowire is reflected by the state of the L2TPv3 session. If the
corresponding session is L2TPv3 down, the pseudowire associated with it must be shut down.
Example
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#session
tunnel1peer1session1 pseudowire-id 5000 traffic-source vlan 10-20 native-vlan
1
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
peer 2 hostname tunnel1peer1 udp port 100
session tunnel1peer1session1 pseudowire-id 5000 traffic-source vlan 10-20
native-vlan 1
router-id 2000
establishment-criteria cluster-master
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
Related Commands:
use
Configures a tunnel to use a specified L2TPv3 tunnel policy and specified critical resources
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
use [critical-resource|l2tpv3-policy]
session
Configures this session’s name
pseudowire-id
<1-4294967295>
Configures the pseudowire ID for this session from 1- 4204067295
traffic-source
vlan
Configures VLAN as the traffic source for this tunnel
•
(for example, 10-20, 25, 30-35).
native-vlan <1-4094>
Optional – Configures the native VLAN ID for this session, which is not tagged
•
<1-4094> – Specify the native VLAN ID from 1- 4094.
Removes a session