Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1241)

Brocade Mobility RFS Controller CLI Reference Guide 1233
53-1003098-01
24
ip default-gateway priority <1-8000>
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#ip default-gateway
priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
router ospf
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
ip default-gateway priority 1
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
network
router-mode
Assigns networks to specified areas (defines the OSPF interfaces and their associated area IDs)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
network area [<0-4294967295>|]
Parameters
network area [<0-4294967295>|]
Example
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#network 1.2.3.0/24
area 4.5.6.7
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#show context
default-gateway Configures the default gateway
priority <1-8000> Sets the priority for the default gateway acquired via OSPF. Specify an integer from 1 - 8000. The default
is 7000.
NOTE: Lower the value, higher is the priority.
no Removes default gateway priority settings
Specifies an OSPF network address/mask value. Defines networks (IP addresses and mask)
participating in OSPF.
area
[<0-4294967295>|] Specifies an OSPF area, associated with the OSPF address range, in one of the following formats:
•
<0-4294967295> – Specifies a 32 bit OSPF area ID from 0 - 4294967295
•
– Defines an OSPF area ID in the form of an IPv4 address