Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1179)

Brocade Mobility RFS Controller CLI Reference Guide 1171
53-1003098-01
21
use
wips-policy
Enables device categorization on this WIPS policy. This command uses an existing device
categorization list. The list categorizes devices as authorized or unauthorized.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use device-categorization
Parameters
use device-categorization
Example
rfs7000-37FABE(config-wips-policy-test)#use device-categorization test
rfs7000-37FABE(config-wips-policy-test)#show context
wips-policy test
event excessive 80211-replay-check-failure threshold-client 10
threshold-radio 99 filter-ageout 9
no event client-anomaly wellenreiter filter-ageout 99
signature test
interference-event
bssid 11-22-33-44-55-66
dst-mac 55-66-77-88-99-00
frame-type reassoc
filter-ageout 8
threshold-client 88
payload 1 pattern brocade offset 1
br-detection-ageout 50
br-detection-wait-time 15
use device-categorization test
rfs7000-37FABE(config-wips-policy-test)#
payload Configures payload settings. The payload command sets a numerical index pattern and offset for this WIPS
signature.
src-mac Configures a source MAC address for the packet examined for matching
ssid-match Configures a SSID for matching
threshold-client Configures a wireless client threshold limit
threshold-radio Configures a radio threshold limit
device-categorization
Configures a device categorization list
•
– Specify the device categorization object name to associate with this
profile