Spanning-tree – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 802
Brocade Mobility RFS Controller CLI Reference Guide
789
53-1003098-01
7
ospf Ospf
passive Make OSPF Interface as passive
redistribute Route types redistributed by OSPF
route-limit Limit for number of routes handled OSPF process
router-id Router ID
vrrp-state-check Publish interface via OSPF only if the interface VRRP
state is not BACKUP
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile default-rfs7000-router-ospf)#
Related Commands:
spanning-tree
Enables spanning tree commands. Use these commands to configure the errdisable, multiple
spanning tree and portfast settings.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
spanning-tree [errdisable|mst|portfast]
spanning-tree errdisable recovery [cause bpduguard|interval <10-1000000>]
spanning-tree mst
[<0-15>|cisco-interoperability|enable|forward-time|hello-time|
instance|max-age|max-hops|region|revision]
spanning-tree mst [<0-15> priority <0-61440>|cisco-interoperability
[enable|disable]|
enable|forward-time <4-30>|hello-time <1-10>|instance
<1-15>|max-age <6-40>|
max-hops <7-127>|region
Disables OSPF settings