Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 359)

Brocade Mobility RFS Controller CLI Reference Guide 343
53-1003098-01
4
encryption-type tkip-ccmp
authentication-type eap
kerberos server timeout 12
kerberos server primary host 172.16.10.2
accounting syslog host 172.16.10.4 port 2
data-rates 2.4GHz gn
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
captive-portal-enforcement fall-back
ip dhcp trust
acl exceed-rate wireless-client-denied-traffic 20 disassociate
enforce-dhcp
broadcast-dhcp validate-offer
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
mac-authentication
wlan-mode commands
Enables MAC authentication. When enabled, the system uses cached credentials (RADIUS server
lookups are skipped) to authenticate clients.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
mac-authentication cached-credentials
Parameters
mac-authentication cached-credentials
Example
rfs4000-229D58(config-wlan-test)#mac-authentication cached-credentials
rfs4000-229D58(config-wlan-test)#
mac-registration
wlan-mode commands
Enables dynamic MAC registration of a user
NOTE
This feature is supported only if MAC authentication is enabled. To enable MAC authentication use
the authentication-type > mac command in the config WLAN mode.
Supported in the following platforms:
mac-authentication
cached-credentials Uses cached credentials to skip RADIUS lookups