Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 949)

938 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
address
dhcp-pool-mode commands
Adds IP addresses to the DHCP address pool. These IP addresses are assigned to each device
joining the network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
address [||range]
address [||range [|]
[|
]] {class }
Parameters
address [||range [|]
[|
]] {class }
next-server Configures the next server in the boot process page 950
no Negates a command or sets its default no
option Configures RAW DHCP options page 935
respond-via-unicast Sends a DHCP offer and DHCP Ack as unicast messages page 956
static-route Configures a static route for a DHCP pool page 956
update Controls the usage of the DDNS service page 957
static-binding Configures static address bindings page 958
Command Description Reference
Adds a single IP address to the DHCP address pool
Adds a single host mapped to the specified host alias. The host alias should be existing and
configured.
A network host alias maps a name to a single network host. For example, ‘alias host $HOST
1.1.1.100’. In this example the host alias is ‘$HOST’ and it maps to a single host ‘1.1.1.100’. For more
information, see
alias .