Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 685)

672 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Set the interface speed to auto detect and use the fastest speed available. Speed detection is
based on connected network hardware.
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#speed 10
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#show context
interface ge1
description This\ is\ GigabitEthernet\ interface\ for\ Royal\ King
speed 10
duplex full
spanning-tree bpduguard enable
spanning-tree bpdufilter disable
spanning-tree force-version 1
spanning-tree guard root
spanning-tree mst 2 port-priority 10
dot1x supplicant username Bob password 0 motorolasolutions@123
ip dhcp trust
ip arp header-mismatch-validation
qos trust dscp
qos trust 802.1p
channel-group 1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Related Commands:
switchport
interface-config-instance
Sets switching mode characteristics for the selected interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
switchport [access|mode|trunk]
switchport access vlan <1-4094>
switchport mode [access|trunk]
switchport trunk [allowed|native]
switchport trunk allowed vlan [|add |none|remove ]
switchport trunk native [tagged|vlan <1-4094>]
Parameters
switchport access vlan <1-4094>
no Resets speed to default (auto)
access vlan <1-4094> Sets the VLAN when interface is in the access mode
•
<1-4094> – Specify the SVI VLAN ID from 1 - 4094.