Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 294)

278 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Example
rfs7000-37FABE(config)#radio-qos-policy test
rfs7000-37FABE(config-radio-qos-test)#?
Radio QoS Mode commands:
accelerated-multicast Configure multicast streams for acceleration
admission-control Configure admission-control on this radio for one or
more access categories
no Negate a command or set its defaults
smart-aggregation Configure smart aggregation parameters
wmm Configure 802.11e/Wireless MultiMedia parameters
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-radio-qos-test)#
NOTE
For more information on radio qos policy, see Chapter 18, RADIO-QOS-POLICY .
Related Commands:
radius-group
Global Configuration Commands
Configures RADIUS user group parameters
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
radius-group
Parameters
radius-group
no Removes an existing Radio QoS policy
Specify a RADIUS user group name. The name should not exceed 64 characters. If the RADIUS user group
does not exist, it is created.