Rf-domain-mode commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 302
286
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
rf-domain {
Parameters
rf-domain {
Example
rfs7000-37FABE(config)#rf-domain rfs7000
rfs7000-37FABE(config-rf-domain-rfs7000)#?
RF Domain Mode commands:
alias Alias
channel-list Configure channel list to be advertised to wireless
clients
contact Configure the contact
control-vlan VLAN for control traffic on this RF Domain
controller-managed RF Domain manager for this domain will be an adopting
controller
country-code Configure the country of operation
layout Configure layout
location Configure the location
mac-name Configure MAC address to name mappings
no Negate a command or set its defaults
override-smartrf Configured RF Domain level overrides for smart-rf
override-wlan Configure RF Domain level overrides for wlan
sensor-server Motorola AirDefense sensor server configuration
stats Configure the stats related setting
timezone Configure the timezone
tree-node Configure tree node under which this rf-domain appears
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-rf-domain-rfs7000)#
rf-domain-mode commands
This section describes the default commands under RF Domain.
rf-domain
Creates a new RF Domain or enters its configuration context
Optional. Specify the RF Domain name (should not exceed 32 characters and should represent the intended
purpose). Once created, the name cannot be edited.
containing
Optional. Identifies an existing RF Domain that contains a specified sub-string in the domain name
•