Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 788)

Brocade Mobility RFS Controller CLI Reference Guide 775
53-1003098-01
7
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
misconfiguration-recovery-time
Profile Config Commands
Verifies connectivity after a configuration is received
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
misconfiguration-recovery-time [0|<60-300>]
Parameters
misconfiguration-recovery-time [0|<60-300>]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#misconfiguration-recovery-time
65
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
bridging-mode isolated-tunnel
.................................................
qos trust 802.1p
interface pppoe1
use firewall-policy default
misconfiguration-recovery-time 65
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
no Disables or reverts settings to their default
<60-300> Sets the recovery time from 60 - 300 seconds (default is 180 seconds)
0 Disables recovery from misconfiguration