Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1306)

1298 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
hysteresis min-threshold -65
hysteresis root-sel-snr-delta 12
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
Related Commands:
monitor
meshpoint-device-commands
Enables monitoring of critical resource and primary port links. It also configures the action taken in
case a critical resource goes down or a primary port link is lost.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
Syntax:
monitor [critical-resource|primary-port-link-loss]
monitor [critical-resource|primary-port-link-loss] action no-root
Parameters
monitor [critical-resource|primary-port-link-loss] action no-root
Example
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#monitor
critical-resource action no-root
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#show context
meshpoint-device test
name test
monitor critical-resource action no-root
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#
Related Commands:
path-method
meshpoint-device-commands
no Removes the configured path selection SNR hysteresis values
critical-resource Enables critical resource down event monitoring
primary-port-link-loss Enables primary port link loss event monitoring
action The following are common to all of the above:
•
action – Sets the action taken if a critical resource goes down or if a primary port link is lost
•
no-root – Changes the meshpoint to be non root (this is the action taken in case any of the
above mentioned two events occur)
no Disables monitoring of critical resource and primary port links.