Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 471)

Brocade Mobility RFS Controller CLI Reference Guide 457
53-1003098-01
6
NOTE
The environmental senor is supported only on an Brocade Mobility 1240 Access Point. When
executed on any controller (other than an Brocade Mobility 1240 Access Point), the show >
environmental-sensor > command displays environmental-sensor details for adopted
Brocade Mobility 1240 Access Points (if any).
Supported in the following platforms:
• Access Points — Brocade Mobility 1240 Access Point
Syntax:
show environmental-sensor
[history|humidity|light|motion|summary|temperature|version]
show environmental-sensor history {<1-HOUR>|<20-MINUTE>|<24-HOUR>}
show environmental-sensor [humidity|light|motion|summary|temperatue|version]
Parameters
show environmental-sensor history {<1-HOUR>|<20-MINUTE>|<24-HOUR>}
show environmental-sensor [humidity|light|motion|summary|temperatue|version]
Example
ap8132-711728#show environmental-sensor summary
Maat Device uptime: 0 days 15:25:11
ERROR: Maat device is offline!
threshold polling-interval: 5
historical data polled 0 times per 2-minutes interval since Maat online
motion-sensor: Enabled(Demo)
current value: 0 detected
-------------------------------
motion detected
-------------------------------
20-minute 0
environmental-sensor
history Displays environmental sensor history once in every hour, 20 minutes, or 24 hours
History includes the humidity, light, motion, and temperature data recorded by the sensor at specified time
interval.
1-hour Optional. Displays environmental sensor history once in every 1 (one) hour
20-minute Optional. Displays environmental sensor history once in every 20 minutes
24-hour Optional. Displays environmental sensor history once in every 24 hours
environmental-sensor Displays environmental sensor’s recorded data, based on the parameters passed. The system displays the
specified recorded data.
The environmental sensor records data at the following intervals: 20 minutes, 1 hour, and 24 hours
humidity Displays the minimum, average, and maximum humidity recorded
light Displays the minimum, average, and maximum light recorded
motion Displays the minimum, average, and maximum motion recorded:
temperature Displays the minimum, average, and maximum temperature recorded
version Displays the hardware and firmware versions
summary Displays a summary of the data recorded at following intervals: