Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 318)

302 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
override-smartrf channel-list [2.4GHz|5GHZ]
Example
rfs7000-37FABE(config-rf-domain-default)#override-smartrf channel-list 2.4GHz
1,2,3
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
contact Bob+919621212577
country-code in
override-smartrf channel-list 2.4GHz 1,2,3
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
override-wlan
rf-domain-mode commands
Configures RF Domain level overrides for a WLAN
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
overrides-wlan [ssid|vlan-pool|wpa-wpa2-psk]
overrides-wlan [ssid |vlan-pool <1-4094> {limit <0-8192>}|
wpa-wpa2-psk ]
Parameters
override-smartrf Enables dynamic channel switching for Smart RF radios
channel-list Configures a list of channels for 2.4 GHz and 5.0 GHz Smart RF radios
2.4GHz
Selects the 2.4 GHz Smart RF radio channels
•
– Specify a list of channels separated by commas.
5GHz
Selects the 5.0 GHz Smart RF radio channels
•
– Specify a list of channels separated by commas.
no Resets the override Smart RF settings its default