Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1347)

Brocade Mobility RFS Controller CLI Reference Guide 1339
53-1003098-01
Appendix
A
CONTROLLER MANAGED WLAN USE CASE
This section describes the activities required to configure a WLAN. Instructions are provided using
the wireless controller CLI.
Creating a First Controller Managed WLAN
CONTROLLER MANAGED WLAN USE CASE
It is assumed you have a Brocade Mobility RFS4000 wireless controller with the latest build
available from Brocade. It is also assumed you have one Brocade Mobility 650 Access Point model
access point and one Brocade Mobility 71XX Access Point model access point, both with the latest
firmware available from Brocade.
Upon completion, you will have created a WLAN on a Brocade Mobility RFS4000 model wireless
controller using a DHCP server to allocate IP addresses to associated wireless clients.
Assumptions
Verify the following conditions have been satisfied before attempting the WLAN configuration
activities described in this section:
• It is assumed the wireless controller has the latest firmware version available from Brocade.
• It is assumed the Brocade Mobility 650 Access Point and Brocade Mobility 71XX Access Point
access points also have the latest firmware version available from Brocade.
• It is assumed there are no previous configurations on the wireless controller or access point
and default factory configurations are running on the devices.
• It is assumed you have administrative access to the wireless controller and access point CLI.
• It is assumed the individual administrating the network is a professional network installer.
Design
This section defines the network design being implemented.