Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 287)

Brocade Mobility RFS Controller CLI Reference Guide 271
53-1003098-01
4
ip-address-type Configure the advertised ip-address-type
nai-realm Configure a NAI realm for the hotspot
net-auth-type Add a network authentication type to the hotspot
no Negate a command or set its defaults
operator Add configuration related to the operator of the
hotspot
roam-consortium Add a roam consortium for the hotspot
venue Set the venue parameters of the hotspot
wan-metrics Set the wan-metrics of the hotspot
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
--More--
rfs4000-229D58(config-passpoint-policy-test)#
Related Commands:
NOTE
For more information on passpoint policy, see Chapter 28, PASSPOINT POLICY .
password-encryption
Global Configuration Commands
Enables password encryption
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
password-encryption secret 2
Parameters
password-encryption secret 2
Example
rfs7000-37FABE(config)#password-encryption secret 2
rfs7000-37FABE(config)#
no Removes an existing passpoint policy
secret 2 Encrypts passwords with a secret phrase
•
2 – Specifies the encryption type as either SHA256 or AES256
•
– Specify the encryption passphrase.