Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 848)

Brocade Mobility RFS Controller CLI Reference Guide 835
53-1003098-01
8
accounting server <1-6> onboard [self|controller]
accounting server <1-6> proxy-mode [none|through-controller|through-mint-host
|through-rf-domain-manager]
accounting server <1-6> timeout <1-60> {attempts <1-10>}
accounting type [start-interim-stop|start-stop|stop-only]
realm-type Selects the match type used on the username
[prefix|suffix] Select one of the following options:
•
prefix – Matches the prefix of the username (For example, username is of type DOMAIN/user1,
DOMAIN/user2). This is the default setting.
•
suffix – Matches the suffix of the username (For example, user1@DOMAIN, user2)@DOMAIN)
realm
Configures the text matched against the username. Enter the realm name (should not exceed 50 characters).
When the RADIUS accounting server receives a request for a user name, the server references a table of user
names. If the user name is known, the server proxies the request to the RADIUS server.
•
– Specifies the matching text including the delimiter (a delimiter is typically '' or '@')
strip Optional. Strips the realm from the username before forwarding the request to the RADIUS server
server <1-6> Configures an accounting server. Up to 6 accounting servers can be configured.
onboard Selects an onboard server instead of an external host
self Configures the onboard server on a AP, wireless controller, or service platform (where the client is
associated)
controller Configures local RADIUS server settings
server <1-6> Configures an accounting server. Up to 6 accounting servers can be configured.
proxy-mode Select the mode used to proxy requests. The options are: none, through-controller, and
through-rf-domain-manager.
none No proxy required. Sends the request directly using the IP address of the device
through-controller Proxies requests through the controller (access point, wireless controller, or service platform) configuring the
device
through-mint-host
Proxies requests through a neighboring MiNT device. Provide the device’s MiNT ID or hostname.
through-rf-domain-manag
er Proxies requests through the local RF Domain Manager
server <1-6> Configures an accounting server. Up to 6 accounting servers can be configured.
timeout <1-60> Configures the timeout for each request sent to the RADIUS server
•
<1-60> – Specify a value from 1 - 60 seconds.
attempts <1-10> Optional. Specifies the number of times a transmission request is attempted
•
<1-10> – Specify a value from 1 - 10.
type Configures the type of RADIUS accounting packets sent. The options are: start-interim-stop, start-stop, and
stop-only.
start-interim-stop Sends accounting-start and accounting-stop messages when the session starts and stops. This parameter
also sends interim accounting updates.
start-stop Sends accounting-start and accounting-stop messages when the session starts and stops. This is the default
setting.
stop-only Sends an accounting-stop message when the session ends