Default-adoption, Deny – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 873
Brocade Mobility RFS Controller CLI Reference Guide
861
53-1003098-01
9
default-adoption
Adopts devices, even when no matching rules are defined. Assigns a default profile and default RF
Domain.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
default-adoption
Parameters
None
Example
rfs4000-229D58(config-auto-provisioning-policy-test)#default-adoption
rfs4000-229D58(config-auto-provisioning-policy-test)#show context
auto-provisioning-policy test
default-adoption
adopt br81xx precedence 1 profile default-br81xx vlan 1
rfs4000-229D58(config-auto-provisioning-policy-test)#
Related Commands:
deny
Defines a deny device adoption rule
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
Disables adoption of devices when matching rules are not found