Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 568)

Brocade Mobility RFS Controller CLI Reference Guide 555
53-1003098-01
7
• Service Platforms — Brocade Mobility RFS9510
Syntax:
autogen-uniqueid
Parameters
autogen-uniqueid
Example
nx4500-5CFA2B(config-profile-testBR6522)#autogen-uniqueid MotoBR6522$SN
nx4500-5CFA2B(config-profile-testBR6522)#show context
autogen-uniqueid MotoBR6522$SN
no autoinstall configuration
no autoinstall firmware
interface radio1
interface ge1
use firewall-policy default
service pm sys-restart
nx4500-5CFA2B(config-profile-testBR6522)#
nx4500-5CFA2B(config-device-B4-C7-99-5C-FA-2B)#autogen-uniqueid
Moto-$MiNT-ID-TechPubs
nx4500-5CFA2B(config-device-B4-C7-99-5C-FA-2B)#show context
nx45xx B4-C7-99-5C-FA-2B
use profile default-nx45xx
use rf-domain default
hostname nx4500-5CFA2B
license AP DEFAULT-12AP-LICENSE
license ADSEC DEFAULT-ADV-SEC-LICENSE
environmental-sensor temperature
autogen-uniqueid Moto-$MiNT-ID-TechPubs
ip default-gateway 192.168.13.2
interface up1
no shutdown
switchport mode access
switchport access vlan 1
interface vlan1
ip address 192.168.13.12/24
logging on
logging console warnings
logging buffered warnings
nx4500-5CFA2B(config-device-B4-C7-99-5C-FA-2B)#
autogen-uniqueid
Autogenerates a device’s unique ID (not exceeding 64 characters in length)
The ID generated is a combination of the text provided and the substitution token $SN or $MiNT-ID. Where
ever the autogen-uniqueid is used the device’s serial number OR MiNT-ID is referenced depending on the
substitution token used.
•
– Specify a auto generate unique ID format using one of the following substitution tokens:
Available tokens:
$SN - references SERIAL NUMBER of the device
$MINT-ID - references MINT-ID of the device
For example, ORG-$SN-DEPT, In this example ‘ORG’ and ‘DEPT’ represent the user-defined prefix and suffix
respectively. And $SN is the substitution token.