Remote-type – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 628
Brocade Mobility RFS Controller CLI Reference Guide
615
53-1003098-01
7
Remote VPN client:
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#pfs 14
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#show context
crypto map test 2 ipsec-isakmp dynamic
peer 1 ikev1 RemoteIKEv1Peer1
local-endpoint-ip 157.235.204.62
pfs 14
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#
remote-type
crypto-map auto-vpn-tunnel/remote-vpn-client instance
Configures the remote VPN client type as either None or XAuth
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
remote-type [none|xauth]
Parameters
remote-type [none|xauth]
Example
Remote VPN client:
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#remote-type
none
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#show context
crypto map test 2 ipsec-isakmp dynamic
peer 1 ikev1 RemoteIKEv1Peer1
local-endpoint-ip 157.235.204.62
pfs 14
remote-type none
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#
remote-type [none|xauth]
Specify the remote VPN’s client type
•
none – Specifies remote VPN client with No XAUTH
•
xauth – Specify remote VPN client as using XAUTH (applicable only for IKEv1). This is the default
setting
XAuth (extended authentication) provides additional authentication validation by permitting an edge
device to request extended authentication information from an IPSec host. This forces the host to
respond with additional authentication credentials. The edge device respond with a failed or passed
message. The default setting is XAuth.