Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 892)

880 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
10
event rogue-br-detection trigger-against
[neighboring|sanctioned|unsanctioned] {(neighboring|sanctioned|unsanctioned)}
Example
rfs7000-37FABE(config-advanced-wips-policy-test)#event dos-cts-flood
threshold cts-frames-ratio 8
rfs7000-37FABE(config-advanced-wips-policy-test)#event dos-eapol-logoff-storm
threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#event probe-response-flood
threshold probe-rsp-frames-count 8
rfs7000-37FABE(config-advanced-wips-policy-test)#event
wlan-jack-attack-detected trigger-against sanctioned
rfs7000-37FABE(config-advanced-wips-policy-test)#event probe-response-flood
trigger-against sanctioned
rfs7000-37FABE(config-advanced-wips-policy-test)#show context
advanced-wips-policy test
event wlan-jack-attack-detected trigger-against sanctioned
event probe-response-flood trigger-against sanctioned
event probe-response-flood threshold probe-rsp-frames-count 8
no event dos-cts-flood trigger-against
event dos-cts-flood threshold cts-frames-ratio 8
no event dos-eapol-logoff-storm trigger-against
event dos-eapol-logoff-storm threshold eapol-start-frames-mu 99
rfs7000-37FABE(config-advanced-wips-policy-test)#
Related Commands:
no
advanced-wips-policy
Negates a command or reverts settings to their default
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [event|server-listen-port|terminate|use]
no event
rogue-br-detection This event occurs when rogue APs are detected in the network.
trigger-against (neighboring,
sanctioned,
unsanctioned) Sets the trigger condition
•
sanctioned – An accidental association event is triggered against sanctioned devices
•
unsanctioned – An accidental association event is triggered against unsanctioned devices
•
neighboring – An accidental association event is triggered against neighboring devices
no Removes or resets triggers against various events