Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 680)

Brocade Mobility RFS Controller CLI Reference Guide 667
53-1003098-01
7
power
interface-config-instance
Configures PoE settings on this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
power {limit <0-40>|priority [critical|high|low]}
Parameters
power {limit <0-40>|priority [critical|high|low]}
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#power
limit 30
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#power
priority critical
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#show
context
interface ge1
ip dhcp trust
qos trust dscp
qos trust 802.1p
power limit 30
power priority critical
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#
shutdown Disables the selected interface
spanning-tree Configures spanning tree parameters
speed Specifies the speed of a FastEthernet or GigabitEthernet port
switchport Sets the interface switching mode characteristics
use Defines the settings to use with this command
write Writes information to the memory or terminal
power Configures power related thresholds for this interface
limit <0-40> Optional. Configures the PoE power limit from 0 - 40 Watts
priority [critical|high|low] Optional. Configures the PoE power priority on this interface
•
critical – Sets PoE priority as critical
•
high – Sets PoE priority as high
•
low – Sets PoE priority as low