Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 729)

716 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#off-channel-scan
channel-list 2.4GHz 1
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
data-rates b-only
mesh client
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
non-unicast tx-rate bss 7 highest-basic
non-unicast tx-rate bss 8 highest-basic
non-unicast tx-rate bss 9 highest-basic
non-unicast tx-rate bss 10 highest-basic
non-unicast tx-rate bss 11 highest-basic
non-unicast tx-rate bss 12 highest-basic
non-unicast tx-rate bss 13 highest-basic
non-unicast tx-rate bss 14 highest-basic
non-unicast tx-rate bss 15 highest-basic
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
placement
interface-config-radio-instance
Defines the location where the radio is deployed. The radio’s placement should depend on the
country of operation selected and its regulatory domain requirements for radio emissions.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
placement [indoor|outdoor]
Parameters
placement [indoor|outdoor]
no Disables radio off channel scanning
indoor Radio is deployed indoors (uses indoor regulatory rules). This is the default setting.
outdoor Radio is deployed outdoors (uses outdoor regulatory rules)