Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 518)

504 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
show session-config {include-factory}
Parameters
show session-config {include-factory}
Example
rfs4000-229D58(config)#show session-config
!
! Configuration of Brocade Mobility RFS4000 version 5.5.0.0-036B
!
!
version 2.3
!
!
client-identity TestClientIdentity
dhcp 1 message-type request option-codes exact hexstring 5e4d36780b3a7f
!
client-identity-group ClientIdentityGroup
client-identity TestClientIdentity precedence 1
!
alias network testNetworkAlias address-range 192.168.13.4 to 192.168.13.10
!
ip access-list BROADCAST-MULTICAST-CONTROL
permit tcp any any rule-precedence 10 rule-description "permit all TCP
traffic"
permit udp any eq 67 any eq dhcpc rule-precedence 11 rule-description "permit
DHCP replies"
deny udp any range 137 138 any range 137 138 rule-precedence 20
rule-description "deny windows netbios"
deny ip any 224.0.0.0/4 rule-precedence 21 rule-description "deny IP
multicast"
deny ip any host 255.255.255.255 rule-precedence 22 rule-description "deny IP
l
--More--
rfs4000-229D58(config)#
sessions
show commands
Displays CLI sessions initiated on a device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show sessions {on }
session-config
include-factory Displays current session configuration
•
include-factory – Optional. Includes factory defaults