Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 335
Brocade Mobility RFS Controller CLI Reference Guide
319
53-1003098-01
4
The following table summarizes WLAN configuration mode commands.
Command
Description
Reference
Defines a WLAN accounting configuration
Defines the actions based on an ACL rule configuration
Allows a WLAN to respond to probes for broadcast ESS
Attaches an existing global association list to a WLAN
Sets a WLAN’s authentication type
Configures how packets to/from this WLAN are bridged
Configures broadcast DHCP packet handling
Advertises a WLAN’s SSID in beacons
Configures a WLAN’s captive portal enforcement
Enables WLAN client access (normal data operations)
Allows the switching of frames from one wireless client to another on a WLAN
Enables load balancing of WLAN clients
Enables controller assisted mobility to determine wireless clients' VLAN assignment
Specifies the 802.11 rates supported on the WLAN
Sets a WLAN’s description
downstream-group-add
ressed-forwarding
Enables forwarding of downstream packets addressed to a group
Configures dynamic VLAN assignment on this WLAN
Configures client access based on eap-type used for authentication
Sets a WLAN’s encryption type
Drops packets from clients with a static IP address
Configures support for 802.11r fast BSS transition on a WLAN
Enables HTTP URL analysis on the WLAN
Configures IP settings
Configures Kerberos authentication parameters
Configures MAC authentication parameters
Enables dynamic MAC registration of user
Enables support for Brocade specific extensions to 802.11
Negates a command or reverts settings to their default
Enables the proxy ARP mode for ARP requests
Enables support for 802.11k radio resource measurement
Configures RADIUS parameters