Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 882)

870 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
9
Example
rfs4000-229D58(config-auto-provisioning-policy-test)#upgrade ap621 precedence
1 any
rfs4000-229D58(config-auto-provisioning-policy-test)#upgrade rfs4000
precedence 2 ip 192.168.13.1 192.168.13.5
rfs4000-229D58(config-auto-provisioning-policy-test)#show context
auto-provisioning-policy test
upgrade ap621 precedence 1 any
upgrade rfs4000 precedence 2 ip 192.168.13.1 192.168.13.5
rfs4000-229D58(config-auto-provisioning-policy-test)#
Related Commands:
no
auto-provisioning-policy
Removes a deny, permit, or redirect rule from the specified auto provisioning policy
Supported in the following platforms:
fqdn Configures the FQDN to match
FQDN is a domain name that specifies its exact location in the DNS hierarchy. It specifies all domain levels,
including its top-level domain and the root domain.
•
– Specify the FQDN. Devices matching the specified value are upgraded.
ip
[
|] Configures a range of IP addresses and subnet address. Devices having IP addresses within the specified
range or are part of the specified subnet are upgraded.
•
– Specify the first IP address in the range.
•
– Specify the last IP address in the range.
•
– Specify the IP subnet and mask to match against the device’s IP address.
lldp-match
Configures the device location to match, based on LLDP snoop strings
LLDP is a vendor neutral link layer protocol used to advertise a network device’s identity, capabilities, and
neighbors on a local area network.
•
– Specify the location. Devices matching the specified string are upgraded.
mac
{} Configures a single or a range of MAC addresses. Devices matching the specified values are upgraded.
•
– Specify the first MAC address in the range. Provide only this MAC address to filter a
single device.
•
– Optional. Specify the last MAC address in the range.
model-number
Configures the device model number
•
– Specify the model number. Devices matching the specified model number are
upgraded.
serial-number
Configures the device’s serial number
•
– Specify the serial number. Devices matching the specified serial number are
upgraded.
vlan Configures the VLAN ID
•
– Specify the VLAN ID. Devices assigned to the specified VLAN are upgraded.
no Removes an upgrade rule