Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 815)

802 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
service watchdog
service wireless br650 legacy-auto-update-image
service wireless client tx-deauth on-radar-detection
service wireless cred-cache-sync [full|interval <30-864000>|never|partial]
service wireless test [max-rate|min-rate] [1,2,5.5,6,11,12,18,24,
36,48,54,mcs0,
mcs1,............mcs23]
service wireless test max-retries <0-15>
service wireless wispe-controller-port <1-65535>
service show cli
service fast-switching
watchdog Enables/disables the watchdog. This feature is enabled by default.
Enabling the watchdog option implements heartbeat messages to ensure other associated devices are up
and running and capable of effectively inter-operating with the controller.
wireless br650 Invokes Brocade Mobility 650 Access Point related service commands
legacy-auto-update-image
Configures the Brocade Mobility 650 Access Point image file details, such as location and file name
•
– Provides the path and name of the Brocade Mobility 650 Access Point image file (for
example, flash:/br.img)
wireless client Configures wireless client and stations related settings
tx-deauth on-radar-detection Enables/disables access points to transmit deauth to clients when changing channels on radar detection
wireless
cred-cache-sync Configures the credential cache’s synchronization parameters. The parameters are: full, interval, never,
and partial.
full Enables synchronization of all credential cache entries
interval <30-864000> Sets the interval, in seconds, at which the credential cache is synchronized
•
<30-864000> – Specify a value from 30 - 864000 seconds.
partial Enables partial synchronization of parameters for associated clients, with credential cache close to aging
out
wireless test Configures the serviceability parameters used for testing
[max-rate|min-rate] Configures the maximum and minimum data rates for clients using rate-scaling
[1,2,5.5,.mcs23] Select the maximum and minimum data rates applicable.
wireless test Configures the serviceability parameters used for testing
max-retries <0-15> Configures the maximum number of retries per packet
wispe-controller-port
<1-65535> Resets the WIreless Switch Protocol Enhanced (WISPe) controller port. This is the UDP port used to listen
for WISPe.
•
<1-65535> – Specify a value from 1 -65535.
show cli Displays running system configuration details
•
cli – Displays the CLI tree of the current mode
fast-switching Enables fast switching of packets in the hardware
Use the no > service > fast-switching to disable this feature.