Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 886)

874 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
10
no Negate a command or set its defaults
server-listen-port Configure local WIPS server listen port number
terminate Add a device to the list of devices to be terminated
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-advanced-wips-policy-test)#
advanced-wips-policy
Table 8 summarizes advanced WIPS policy configuration commands.
event
advanced-wips-policy
Configures anomalous frame detection in a RF network
Supported in the following platforms:
TABLE 8 Advanced-WIPS-Policy-Config Commands
Command Description Reference
event Configures event monitoring settings page 874
no Negates a command or sets its default page 880
server-listen-port Sets a local WIPS server’s listening port page 882
terminate Adds a device to a list of terminated devices page 883
use Defines the settings used with the advanced WIPS policy page 883
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance configurations page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425