Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1299
Brocade Mobility RFS Controller CLI Reference Guide
1291
53-1003098-01
27
Syntax:
meshpoint-device
Parameters
meshpoint-device
Example
rfs7000-37FABE(config)#profile br71xx AP71XXTestProfile
rfs7000-37FABE(config-profile-AP71XXTestProfile)#meshpoint-device test
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#?
Mesh Point Device Mode commands:
Mesh Point Device Mode commands:
acs Configure auto channel selection parameters
exclude Exclude neighboring Mesh Devices
hysteresis Configure path selection SNR hysteresis values
monitor Event Monitoring
no Negate a command or set its defaults
path-method Path selection method used to find a root node
preferred Configure preferred path parameters
root Set this meshpoint as root
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-AP71XXTestProfile-meshpoint-test)#
br7131-139B34(config-device-00-23-68-13-9B-34)#meshpoint-device test
br7131-139B34(config-device-00-23-68-13-9B-34-meshpoint-test)#?
Mesh Point Device Mode commands:
acs Configure auto channel selection parameters
exclude Exclude neighboring Mesh Devices
hysteresis Configure path selection SNR hysteresis values
monitor Event Monitoring
no Negate a command or set its defaults
path-method Path selection method used to find a root node
preferred Configure preferred path parameters
root Set this meshpoint as root
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
meshpoint-device
Configures the AP as a meshpoint device and sets its parameters
The meshpoint to configure the AP with