Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 699
686
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
radio-share-mode Configure the radio-share mode of operation for
this radio
rate-selection Default or Opportunistic rate selection
remove-override Negate a command or set its defaults
rf-mode Configure the rf-mode of operation for this radio
rifs Configure Reduced Interframe Spacing (RIFS)
parameters
rts-threshold Configure the RTS threshold
shutdown Shutdown the selected radio interface
sniffer-redirect Capture packets and redirect to an IP address
running a packet capture/analysis tool
stbc Configure Space-Time Block Coding (STBC) parameters
use Set setting to use
wireless-client Configure wireless client related parameters
wlan Enable wlans on this radio
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
The following table summarizes the radio interface configuration commands.
Commands
Description
Reference
Enables Aeroscout multicast packet forwarding
Configures 802.11n aggregation parameters
Enables fair access for clients based on airtime usage
Transmits antenna diversity for non-11n transmit rates
Enables Advanced Element Panel Technology (ADEPT) antenna mode
Specifies the antenna gain for the selected radio
Configures the radio antenna mode
Configures beacon parameters
Configures a radio’s channel of operation
Specifies the 802.11 rates supported on a radio
Configures the selected radio’s description
Reverts to configured home channel once Dynamic Frequency Selection (DFS)
evacuation period expires
Enables automatic antenna mode selection
Enables Ekahau multicast packet forwarding
Configures extended range
Configures the 802.11n guard interval