Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 609
596
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-test-ikev2-policy-ikev2-testpolicy)#
NOTE
IKEv2 being an improved version of the original IKEv1 design, is recommended in most
deployments. IKEv2 provides enhanced cryptographic mechanisms, NAT and firewall traversal,
attack resistance etc.
The following table summarizes crypto IKEv1/iKEv2 commands.
dpd-keepalive
crypto-ikev1/ikev2-policy commands
Sets the DPD keep-alive packet interval
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
dpd-keepalive <10-3600>
Parameters
dpd-keepalive <10-3600>
Example
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-policy-ikev1-testpolicy)#
dpd-keepalive 11
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-policy-testpolicy)#show
context
crypto ikev1 policy testpolicy
Command
Description
Reference
Sets DPD keep alive packet interval
Sets the maximum number of attempts for sending Dead-Peer-Detection (DPD) keep alive
packets (applicable only to the IKEv1 policy)
Configures ISAKMP proposals
Specifies how long an IKE SA is valid before it expires
Sets the mode of the tunnels (applicable only to the IKEv1 policy)
Negates a command or sets its default
<10-3600>
Specifies the interval, in seconds, between successive DPD keep alive packets.The IKE keep alive
message interval is used to detect a dead peer on the remote end of the IPSec VPN tunnel. Specify the
time from 10 - 3600 seconds. The default is 30 seconds