Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 558)

Brocade Mobility RFS Controller CLI Reference Guide 545
53-1003098-01
7
adopter-auto-provisioning-policy-lookup
Profile Config Commands
Enables the use of a centralized auto provisioning policy on this profile or device
When applied on devices adopted by a controller, this profile allows the devices to use a centralized
auto provisioning policy.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use-adopter-auto-provisioning-policy-lookup
Parameters
None
Example
rfs4000-229D58(config-profile-testBrocade Mobility
RFS4000)#adopter-auto-provisioning-policy-lookup
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#show context
profile rfs4000 testBrocade Mobility RFS4000
bridge vlan 1
tunnel-over-level2
ip igmp snooping
ip igmp snooping querier
no autoinstall configuration
no autoinstall firmware
device-upgrade persist-images
.......................................................................
qos trust 802.1p
interface ge4
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface ge5
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface wwan1
interface pppoe1
use firewall-policy default
service pm sys-restart
use-adopter-auto-provisioning-policy
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#