Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 859)

846 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
8
no accounting server <1-6> {dscp|nai-routing|proxy-mode|retry-timeout-factor|
timeout}
no accounting type
no attribute
[acct-delay-time|acct-multi-session-id|chargeable-user-identity|cisco-vsa
audit-session-id|framed-mtu|location-information|nas-ipv6-address|operator-na
me|
service-type]
no authentication eap wireless-client [attempts|identity-request-timeout|
retry-timeout-factor|timeout]
no authentication protocol
no accounting server
<1-6> Resets the RADIUS accounting server’s (identified by its index number) settings
dscp Optional. Resets the DSCP value for RADIUS accounting
nai-routing Optional. Disables NAI forwarding requests
proxy-mode Optional. Resets proxy mode to the default of “no proxying”
retry-timeout-factor Optional. Resets retry timeout to its default of 100
timeout Optional. Resets access parameters, such as timeout values and retry attempts to their default
no accounting type Resets the type of RADIUS accounting packets generated, to its default (start/stop)
no attribute acct-delay-time Disables support for accounting-delay-time attribute in accounting requests
no attribute
acct-multi-session-id Disables support for accounting-multi-session-id attribute
no attribute
chargeable-user-identity Disables support for chargeable-user-identity attribute
no attribute cisco-vsa
audit-session-id Removes the configured CISCO VSA audit session ID
no attribute framed-mtu Resets Framed-MTU RADIUS server attribute in access and accounting requests
no attribute
location-information Disables support for RFC5580 location information attribute
no attribute
nas-ipv6-address Disables support for the NAS IPv6 address attribute
no attribute service-type Disables support for the service-type (6) attribute
no authentication eap
wireless-client Resets EAP parameters for wireless clients
attempts Resets the number of times a RADIUS request is sent to a wireless client to default (3)
identity-request-retry-timeo
ut Resets the interval after which an EAP-identity request to the wireless client is retried
identity-request-timeout Resets EAP identity request timeout to its default
retry-timeout-factor Resets EAP retry timeout to its default of 100
timeout Resets EAP timeout to its default
authentication protocol Resets the authentication protocol used for non-EAP authentication to its default (PAP authentication)