Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 744)

Brocade Mobility RFS Controller CLI Reference Guide 731
53-1003098-01
7
Related Commands:
wireless-client
interface-config-radio-instance
Configures wireless client parameters on this radio
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
wireless-client tx-power [<0-20>|mode]
wireless-client tx-power mode [802.11d {symbol-ie}|symbol-ie {802.11d}]
Parameters
wireless-client tx-power <0-20>
wireless-client tx-power mode [802.11d {symbol-ie}|symbol-ie {802.11d}]
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#wireless-client
tx-power 20
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
rf-mode sensor
placement outdoor
mesh client
rts-threshold 100
wireless-client tx-power 20
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
rifs tx-only
use association-acl-policy test
sniffer-redirect omnipeek 172.16.10.1 channel 1
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
no Dissociates the specified association ACL policy and radio QoS policy
wireless-client Configures wireless client parameters
tx-power <0-20> Configures the transmit power indicated to wireless clients
•
<0-20> – Specify transmit power from 0 - 20 dBm
wireless-client Configures wireless client parameters
tx-power
[802.11d|symbol-ie] Configures the transmit power indicated to wireless clients
•
802.11d – Advertises in the IEEE 802.11d country information element
•
symbol-ie – Optional.
•
symbol-ie – Advertises in the Symbol (176)
•
802.11d – Optional. Advertises in the IEEE 802.11d country information element