Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 520)

506 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
Example
nx9500-6C874D#show site-config-diff 5C-0E-8B-18-06-F4
---- Config diff for switch 5C-0E-8B-18-06-F4 ----
rfs6000 5C-0E-8B-18-06-F4
interface pppoe1
no shutdown
nx9500-6C874D#
smart-rf
show commands
Displays Smart RF management commands
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show smart-rf [br|calibration-config|calibration-status|channel-distribution|
history|history-timeline|interfering-br|interfering-neighbors|radio]
show smart-rf br {||activity|energy|neighbors|on
}
show smart-rf br {|} {on }
show smart-rf br (activity|energy|neighbors} [|] {(on
)}
show smart-rf [calibration-config|calibration-status|channel-distribution|
history|history-timeline] {on }
show smart-rf radio
{|activity|all-11an|all-11bgn|channel|energy|neighbors|
on }
show smart-rf radio {|all-11an|all-11bgn|energy } {on }
show smart-rf radio {activity|neigbors} {|all-11an|all-11bgn} {on
}
show smart-rf interfering-br {||on}
show smart-rf interfering-neighbors {||on|threshold
<50-100>}
Parameters
show smart-rf br {|} {on }
br Displays access point related commands
Optional. Uses MAC addresses to identify access points. Displays all access points, if no MAC address is
specified.