Wips-policy – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1154
1146
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
•
address-match rule: This signature matches one or more address fields. The address fields
supported are BSSID, source-MAC, and destination-MAC. You can also specify frame types to
match. The frame types supported are assoc, auth, beacon, data, deauth, disassoc, mgmt,
probe-request, and probe-response.
A WIPS policy, once configured, has to be attached to a RF Domain to take effect. Multiple WIPS
policies can be configured at the same time, but only one policy can be attached to a given RF
Domain at any time.
NOTE
To attach a WIPS policy to a RF Domain, in the RF Domain configuration mode, execute the use >
wips-policy
.
Use the (config) instance to configure WIPS policy commands. To navigate to the WIPS policy
instance, use the following commands:
rfs7000-37FABE(config)#wips-policy test
rfs7000-37FABE(config-wips-policy-test)#?
Wips Policy Mode commands:
br-detection Rogue AP detection
enable Enable this wips policy
event Configure an event
history-throttle-duration Configure the duration for which event duplicates
are not stored in history
interference-event Specify events which will contribute to smart-rf
wifi interference calculations
no Negate a command or set its defaults
signature Signature to configure
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-wips-policy-test)#
wips-policy
summarizes WIPS policy configuration commands.
TABLE 19
WIPS-Policy-Config Commands
Command
Description
Reference
Defines the WIPS AP detection configuration
Enables a WIPS policy