Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 689)

676 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
The following table summarizes interface VLAN configuration commands.
crypto
interface-config-vlan-instance
Sets encryption module for this VLAN interface. The encryption module (crypto map) is configured
using the crypto map command. For more information, see
crypto .
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
crypto map
Parameters
Commands Description Reference
crypto Defines the encryption module page 676
description Defines the VLAN interface description page 7-677
dhcp-relay-incoming Allows an onboard DHCP server to respond to relayed DHCP packets on this interface page 678
ip Configures Internet Protocol (IP) config commands page 678
no Negates a command or sets its default page 7-680
shutdown Shuts down an interface page 7-683
use Defines the settings used with this command page 7-684
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug (config-if) instance configurations page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425