Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 776)

Brocade Mobility RFS Controller CLI Reference Guide 763
53-1003098-01
7
logging
Profile Config Commands
Enables message logging and configures logging settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
logging [aggregation-time|buffered|console|facility|forward|host|on|syslog]
logging [aggregation-time <1-60>|host |on]
logging [buffered|console|syslog|forward]
[<0-7>|emergencies|alerts|critical|errors|
warnings|notifications|informational|debugging]
logging facility [local0|local1|local2|local3|local4|local5|local6|local7]
Parameters
logging [aggregation-time <1-60>|host |on]
logging [buffered|console|syslog|forward] [<0-7>|emergencies|alerts|critical|
errors|warnings|notifications|informational|debugging]
aggregation-time
<1-60> Sets the number of seconds for aggregating repeated messages
•
<1-60> – Specify a value from 1 - 60 seconds.
host Configures a remote host to receive log messages. Defines numerical (non DNS) IP addresses for external
resources where logged system events can be sent on behalf of the controller profile.
•
– Specify the IP address of the remote host.
on Enables the logging of system messages
buffered Sets the buffered logging level
console Sets the console logging level
syslog Sets the syslog server’s logging level
forward Forwards system debug messages to the wireless controller or service platform