Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 112)

Brocade Mobility RFS Controller CLI Reference Guide 95
53-1003098-01
3
rfs7000-37FABE(config-device-00-15-70-37-FA-BE)#
rfs7000-37FABE#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
rfs7000-37FABE(config)#
connect
Privileged Exec Mode Commands
Begins a console connection to a remote device using the remote device’s MiNT ID or name
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
connect [mint-id |]
Parameters
connect [mint-id |]
Example
rfs4000-229D58#show mint lsp-db
1 LSPs in LSP-db of 68.22.9D.58:
LSP 68.22.9D.58 at level 1, hostname "rfs4000-229D58", 0 adjacencies, seqnum
1073
rfs4000-229D58#
rfs4000-229D58#connect mint-id 68.22.9D.58
Entering character mode
Escape character is '^]'.
Brocade Mobility RFS4000 release 5.5.0.0-018D
rfs4000-229D58 login: admin
Password:
rfs4000-229D58>
copy
Privileged Exec Mode Commands
mint-id Connects to a remote system using the MiNT ID
•
– Specify the remote device’s MiNT ID.
Connects to a remote system using its name
•
– Specify the remote device’s name.