Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 460)

446 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
show clock {on }
Example
rfs7000-37FABE(config)#show clock
2013-02-15 15:38:47 UTC
rfs7000-37FABE(config)#
cluster
show commands
Displays cluster information (cluster configuration parameters, members, status etc.)
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show cluster [configuration|members|status]
show cluster [configuration|members {detail}|status]
Parameters
show cluster [configuration|members {detail}|status]
Example
rfs7000-37FABE(config)#show cluster configuration
Cluster Configuration Information
Name : Cluster1
Configured Mode : Active
Master Priority : 128
Force configured state : Disabled
Force configured state delay : 5 minutes
Handle STP : Disabled
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show cluster members detail
-----------------------------------------------------------------------------
---
ID MAC MODE AP COUNT AAP COUNT AP LICENSE AAP LICENSE
VERSION
clock Displays a system’s clock
on Optional. Displays system clock on a specified device
•
– Specify the name of the AP, wireless controller, service platform, or RF Domain.
cluster Displays cluster information
configuration Displays cluster configuration parameters
members {detail} Displays cluster members configured on the logged device
•
detail – Optional. Displays detailed information of known cluster members
status Displays cluster status