Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 371)

Brocade Mobility RFS Controller CLI Reference Guide 355
53-1003098-01
4
Usage Guidelines:
Ensure the system clock is configured correctly.
Example
rfs7000-37FABE(config-wlan-test)#time-based-access days weekdays start 10:00
end
16:30
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid testWLAN1
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
time-based-access days weekdays start 10:00 end 16:30
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
--More--
rfs7000-37FABE(config-wlan-test)#
use
wlan-mode commands
This command associates an existing captive portal with a WLAN.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use
[aaa-policy|association-acl-policy|captive-portal|ip-access-list|mac-access-l
ist|
passpoint-policy|wlan-qos-policy]
use [aaa-policy |association-acl-policy
|
captive-portal |passpoint-policy
|
wlan-qos-policy ]
use ip-access-list [in|out]
use mac-access-list [in|out]
Parameters