Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1005)

Brocade Mobility RFS Controller CLI Reference Guide 995
53-1003098-01
14
Example
rfs7000-37FABE(config-rw-policy-test)#ip-mac conflict drop-only
rfs7000-37FABE(config-rw-policy-test)#ip-mac routing conflict log-and-drop
log-level notifications
rfs7000-37FABE(config-fw-policy-test)#show context
firewall-policy test
ip dos fraggle drop-only
ip dos tcp-sequence-past-window drop-only
ip dos tcp-max-incomplete high 600
ip dos tcp-max-incomplete low 60
ip-mac conflict drop-only
ip-mac routing conflict log-only log-level notifications
flow timeout icmp 16000
flow timeout udp 10000
flow timeout tcp established 1500
flow timeout other 16000
dhcp-offer-convert
dns-snoop entry-timeout 35
rfs7000-37FABE(config-fw-policy-test)#
Related Commands:
logging
firewall-policy
Configures enhanced firewall logging
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
logging [icmp-packet-drop|malformed-packet-drop|verbose]
logging verbose
logging [icmp-packet-drop|malformed-packet-drop] [all|rate-limited]
Parameters
informational Numerical severity 6. Indicates a informational condition
notification Numerical severity 5. Indicates a normal but significant condition
warnings Numerical severity 4. Indicates a warning condition. This is the default setting.
no Disables actions based on device IP MAC table, IP address, and MAC address conflict detection