Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1329)

Brocade Mobility RFS Controller CLI Reference Guide 1321
53-1003098-01
28
3gpp mcc 505 mnc 14
rfs4000-229D58(config-passpoint-policy-test)#
Related Commands:
roam-consortium
passpoint-policy
Configures a list of Roaming Consortium (RC) Organization Identifiers (OIs) supported on this
hotspot. The beacons and probe responses communicate this Roaming Consortium list to devices.
This information enables a device to identify the networks available through this AP.
Each OI identifies a either a group of Subscription Service Providers (SSPs) or a single SSP.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
roam-consortium hex
Parameters
roam-consortium hex
Example
rfs4000-229D58(config-passpoint-policy-test)#roam-consortium hex 223344
rfs4000-229D58(config-passpoint-policy-test)#
rfs4000-229D58(config-passpoint-policy-test)#show context
hotspot2-policy test
connection-capability ip-protocol 2 port 10 closed
domain-name TechPubs
no internet
ip-address-type ipv6 available
nai-realm mai.testrealm.com
net-auth-type accept-terms url www.motorolasolutions.com
operator name emergencyservices
roam-consortium hex 223344
3gpp mcc 505 mnc 14
rfs4000-229D58(config-passpoint-policy-test)#
no Removes the operator friendly name configured for this passpoint policy
roam-consortium
hex Adds a Roaming Consortium OI to this hotspot in hexadecimal format
•
– Specify the Roaming Consortium OI in hexadecimal format (should not exceed 128
characters)
hex Configures a hexadecimal input
•
– Specify the Roaming Consortium OI in hexadecimal format (should not exceed 128
characters)